|
Air Soldier Products ION QEV Kit
From the Web site:
Our new QEV (Quick Exhaust Valve) kit for the ION increases the gun's cycle speed by venting air right at the port rather than having to route the air back to the solenoid for venting the exhaust. Requires no cutting of the body for installation - it's entirely a 'drop in' mod.
 |
| ASP ION QEV Kit |
Comments
The Clippard MEV-2 is the heart of this QEV
kit. The MEV-2 is one of the most compact QEV's on the market,
little bit more compact than the Pneumadyne/PPS units. Pre-attached
is a quick disconnect. This will allow you to easily assemble and
disassemble your Ion.
 |
| ASP ION QEV Kit |
Installation
Installation instructions are provided on the back of the
packaging.
- Remove the grip frame from the gun body as per the
instruction manual.
- Unscrew the front banjo fitting from the body (the
one right next to the eye connector).
- Pull the banjo fitting off the 1/8" OD tubing
(push the fittings gray end cap while pulling out the tubing).
- Spin the QEV assembly into the front port of the body
(where the banjo fitting has been). Do not overtighten - just
make sure that the sealing o-ring is slightly compressed and that the
silver quick disconnect fitting points to the rear of the gun.
- Trim off 1/4" of the 1/8" OD tubing (as the
new QEV assembly sticks out further than the banjo fitting had)
- Insert the end of the 1/8" OD tubing into the
silver fitting on the QEV assembly.
- Reassemble, gas up, check for leaks, and go play.
Conclusion This
is a great drop in QEV Kit that provides you all the parts you need at a
great price. The Details
- MSRP: $18.00
- MANUFACTURER:
Air Soldier Products www.airsoldier.com
- PROs: Numerous
adjustment options allowing you to set the trigger just the way you like it.
- CONs: A
little pricey for some peoples liking. Performance has a cost and this
trigger is well worth the money. There will be a lower cost trigger with
less features in the near future.
|
